Microprocessor Trainer Kit

Product Description

Microprocessor Trainer Kit (LED):

Micro Teknik Microprocessor Trainer Kit based on 16 bit 8086 Microprocessor, which is widely used to train engineers to develop software/hardware for any industrial process & control.This Kit consists of power-full Monitor EPROM, RAM, I/O Lines, Timer/Counter, Serial, Seven Segment Display and Keyboard for Man to Machine Interface.Features.

Features
    6K Bytes of EPROM with 16K bytes of Battery Backup RAM
    72 I/O Lines, Three Channel Timer/Counter, PC Serial Interface using USART, Interrupt Controller   
    Seven Segment Display with 28 Keys Hex Keypad  
    Power-full Command like Single Stepping, Break Point, Full Clock Execution,  Examine Memory/ Register
    Uploading & Downloading to and from PC in Windows98/XP/NT
    In-Built Power Supply                                    

Specifications

    8086/8088 CPU operating at 2.5/5MHz                              
    8086 Processor can be replaced by 8088 Processor           
    On-board sockets provided to facilitate the use of 8087 Coprocessorand 8089 I/O Processor
    16K bytes of RAM using two nos. of 6264 with Battery Backup expandable up to 256KB  
    16K bytes of powerful monitor EPROM using two nos. of 27512
    72 I/O lines through 3 nos. of 8255 brought at 26 Pins FRC Connector to  interface with IC-XX Series 
    16 bit Timer/Counter through 8253 brought out at 20 Pins FRC Connector
    RS-232C interface using 8251 brought out at 9 Pins DType Connector. On-board Interrupt controller using 8259 brought out at 20 Pins FRC Connector
    28 keys hexadecimal keyboard and eight seven segment display using 8279
    Two modes of operation:
    -Keyboard Mode
    -Serial Mode     
    Powerful Commands like Examine/Edit Memory, Examine/Edit Register, Single stepping, Execution, Block Move can be used through hex keyboard or PC serial mode
    Facility for Downloading/Uploading files from/to PC
    All address, data & control lines are available on KXT Bus 50 pin FRC Connector to interface with SC-XX Series
    All ICS are mounted on IC Sockets.   
    Bare board Tested Glass Epoxy SMOBC PCB is used
    In-Built Power Supply of +5V/2A, š±12V/250mA
    Attractive Wooden enclosures of Light weight Australian Pine Wood
    User's Manual with sample programs
    290mm x 210mm x 105mm (L x W x H)
    Weight 3 Kgs
    Optional
     PRINTER INTERFACE to interface with DOT MATRIX Printer